Difference between revisions of "Aura/JetiUse/LegacyUDI"

Revision as of 16:20, 20 September 2019

Legacy Jeti Setup Notes Using UDI input

This document will provide the instructions and reference materials. Please START by downloading and thoroughly reviewing this file:

• Click here for a pdf of general instructions notes, and reference material

Remember Aura Expects one Aileron, one Elevator, and one Rudder signal along with a Flight Mode change Signal (as listed in the Reference Materials) to provide basic function.

Note: These instructions apply to the standard Aura 8 and to the Aura Professionals while noting that Port A is the preferred UDI input for Aura Professionals.

Open Stock Aura Programming

For Aura Quick Setup users It works just like other supported brands when using the .JSN files above, and auto-detects as JR Mode B! Connect your UDI Pin/Port to servo Port B of the standard Aura 8. (Port A is preferred for the Aura Professionals)

For Open Stock Aura Config Tool users, it is highly recommended that you use the New Aura Config File (Wizard) and create a model file specifically for your model. We do provide these files for Test/Reference however.

• Click here to download an Aura Config File for a typical sport/scale model
• Click here to download an Aura Config File for a typical 3D model

Helpful links for Jeti Information and Firmware

• Use this Standard Firmware Version for 12 channels in to Aura via UDI Standard R3/RSW-18US 3.24 (June, 2015)
• Jeti Firmware Page (reference)

NOTE: The special UDI 16 3.24 firmware has a different Header ID byte and is not supported at this time.
NOTE: The S.bus 3.24 firmware has not been tested and is not supported by Flex Innovations.

Check/Update your Jeti receiver firmware before continuing! Firmware 3.24 standard or higher is considered MANDATORY by Flex Innovations.