Difference between revisions of "Cypher/BuildTips"

From Flex Innovations Wiki
Jump to: navigation, search
(Build Tips)
(Build Tips)
Line 9: Line 9:
 
:2. Once the vertical fins have dried, use a #1 Phillips screwdriver and the screws removed from the tilt setup section to secure the rear hatch assembly onto the fuselage. Note that the two '''''larger diameter''''' screws are used for the front mount locations.
 
:2. Once the vertical fins have dried, use a #1 Phillips screwdriver and the screws removed from the tilt setup section to secure the rear hatch assembly onto the fuselage. Note that the two '''''larger diameter''''' screws are used for the front mount locations.
 
*Page 28, step four:
 
*Page 28, step four:
*When installing the wing, the corner of the aft edge aligning tab interferes slightly with the socket. It can be simply pushed in from the tip and will pop right in. If you prefer, you can trim the corner of the tab a couple of millimeters.
+
*When installing the wing, the corner of the aft edge aligning tab interferes slightly with the socket. It can be simply pushed in from the tip and will pop right in. If you prefer, you can chamfer the corner of the tab a couple of millimeters.
 
**For the grey painted Cyphers, you do '''not''' need to put wing tape on the '''top painted surface'''. You can put an extra tape long ways over the servo wire on  bottom. This is also ok for the white Cyphers.
 
**For the grey painted Cyphers, you do '''not''' need to put wing tape on the '''top painted surface'''. You can put an extra tape long ways over the servo wire on  bottom. This is also ok for the white Cyphers.
  

Revision as of 17:28, 9 September 2019

Build Tips

  • The manual printing is dark. If you need to see certain photos better, you can view the PDF online by clicking on this Manual Link
  • The manual does not cover installing the wheels on the axles.
    • Place a wheel onto an axle
    • Apply blue thread lock to the set screw
    • Install wheel collar and snug the set screw with the included 1.5mm hex driver
  • Page 26, step two should read:
2. Once the vertical fins have dried, use a #1 Phillips screwdriver and the screws removed from the tilt setup section to secure the rear hatch assembly onto the fuselage. Note that the two larger diameter screws are used for the front mount locations.
  • Page 28, step four:
  • When installing the wing, the corner of the aft edge aligning tab interferes slightly with the socket. It can be simply pushed in from the tip and will pop right in. If you prefer, you can chamfer the corner of the tab a couple of millimeters.
    • For the grey painted Cyphers, you do not need to put wing tape on the top painted surface. You can put an extra tape long ways over the servo wire on bottom. This is also ok for the white Cyphers.

Angle Mode Calibration

Please Calibrate the accelerometer before first flights as described in the manual an on the Cypher Wiki Main Page

Key adjustments before first flight for smooth transitions! Set per manual:

  • Adjust fan angle with gauges for
    • 45 degree/Magic
    • 0 degree/Forward Flight
    • Hover fan angle.
  • Adjust elevon angles with gauge.
  • Check CG
  • NOTE: The elevon gauge sets the Cypher conservatively. Your Cypher is likely to climb a bit in forward flight initially. If adjustments are needed, land and turn the elevon clevises. Example, if climbing, turn both clevises in 1 turn and try again. Repeat as needed.
Initially climbing is better than diving!


Cypher Wiki Main