Cypher/GraupnerInput

From Flex Innovations Wiki
Revision as of 21:23, 20 September 2019 by FlexTeam (Talk | contribs) (Reversing)

Jump to: navigation, search

Setup for using a Graupner HOTT Tx/Rx

SUMD Connects like SBUS



Always start with a reset/new transmitter model!

NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the Graupner Rx to the FLEXF3. This is the same cable arrangement shown on page 15 of the manual for the Futaba connections. (Non-Telemetry)
These instructions supplement the printed manual. Please read the manual before proceeding.




CYPHER/Betaflight Settings

Use one of the Betaflight configuration tools to make these settings. Be sure to SAVE the configuration page after adjustments.
We have not tested Graupner Telemetry at this time. If you have information, you can send it to support@flexinnovations.com and we can update our content.

Configuration Page

Betaflight Serial Provider Setting
Betaflight Channel Map Setting
Out of the box, only the 'Serial Receiver Provider' should need a change.
Receiver Mode            ->  Serial Based Receiver (Cypher Default)
Serial Receiver Provider ->  SUMD                  (aka Graupner SUMD)
Telemetry slider         ->  OFF                   (Cypher Default)
SAVE the page!

Receiver Page

Should be same as out of box, but you can check!
Channel Order            ->  TAER1234   (Cypher Default - Same order as Spektrum)
SAVE the page!




Graupner Transmitter settings:

MX16 Mode 2 transmitter and GR-16 receiver used for validations
(Most common models expected to work the SAME)
Receiver with diversity and SUMD out capability recommended.
You can verify the completed settings using the tools using the BetaFlight Receiver page.

Setup

Name:                  Cypher
Model Type:            Plane/Acro
Wing type:             1 Ail, 0 Flaps          (default)
Tail type:             Normal 1 Elev 1 Rudd    (default)
Throttles:             1                       (default)
The rest are defaults                          (default)
Assign a 2-position switch to CH5              (Stability/Angle Mode)
Assign a 3-position switch to CH6              (Configuration/Tilt)
Bind your Transmitter and Receiver
Set your system to output SUMD serial data
No Subtrim should be used

Reversing

1   Throttle        =>
2   Aileron         <= † 
3   Elevator        => †
4   Rudder          <= †
5   Gear            =>    -or as desired
6   Aux1            <= ‡  -or as desired
NOTE: Check 'reversing' by rotating the virtual 'body' on the Receiver Page of the Configurator
NOTE‡: The internal Flex pilots set the CH6 switch UP/Back for forward flight and Low/Front for Hover. You can set per your preference.


Travel

Betaflight Travel Tune Notes
1    Throttle           +-125%  
2    Aileron            +-125%
3    Elevator           +-125%
4    Rudder             +-125%
5    Profile-Stab       +-125%
6    Config-Tilt        +100 -60%  To Start - MUST adjust with gauges!
NOTE: Go to the Receiver Page in Configurator and fine tune Aileron,Elevator, and Rudder travel to 1000-1500-2000. (See notes on top of Configurator page)


Timers

Set a count down
Timer length suggestion for first flights
     2200mAh:            2:30
     2600mAh:            3:00
     3300mAh:            3:40


Cypher Wiki Main