Cypher/JRDMSSInput
From Flex Innovations Wiki
Revision as of 16:44, 10 August 2019 by FlexTeam (Talk | contribs) (Created page with "== '''Setup for using a Jeti Tx/Rx''' == <br /> Betaflight Provider Setting '''<big>Always start with a reset/new transmitter...")
Setup for using a Jeti Tx/Rx
Always start with a reset/new transmitter model!
NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the Jeti Rx to the FLEXF3. This is the same cable arrangement shown on page 15 of the manual for the Futaba connections. (Non-Telemetry)
CYPHER/Betaflight Settings
Use one of the Betaflight configuration tools to make these settings. Be sure to SAVE the page after adjustments.
Configuration Page
Receiver Mode -> Serial Based Receiver (Cypher Default) Serial Receiver Provider -> JETIEXBUS Telemetry slider -> OFF (Cypher Default - Unless configuring with telemetry based using the other supplementary instructions)
Receiver Page
Channel Order -> TAER1234 (Cypher Default - Same order as Spektrum)
JETI Transmitter settings:
DS-16 Mode 2 transmitter and R3 EX RSW Receiver used for validations
(Most common models expected to work the SAME)
You can verify the completed settings using the tools using the BetaFlight Receiver page.
Model->New Model
Name: FV-31 Cypher Model Type: Aero
Bind to Rx per Jeti instructions (verify function with servo in port 2 if desired)
Model->Basic Properties
Name: FV-31 Cypher Wing type: 0 Flaps, 1 Ail Tail type: Normal 1H1V (default) Engine count: 1 (default) The rest are defaults (default)