Difference between revisions of "Cypher/Telemetry"
From Flex Innovations Wiki
| Line 10: | Line 10: | ||
*Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T | *Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T | ||
*Bind the receiver to the transmitter | *Bind the receiver to the transmitter | ||
| − | *Connect to FLEXF3 using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers) | + | *Connect to '''FLEXF3''' using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers) |
*Use your configuration tool to: | *Use your configuration tool to: | ||
**On '''Configuration''' page | **On '''Configuration''' page | ||
| − | ***Make sure ''Receiver Mode'' is set to a serial based receiver. | + | ***Make sure ''Receiver Mode'' is set to a '''''serial based receiver'''''. |
| − | ***Make sure ''Serial Receiver Provider'' is set to SPEKTRUM2040/SRXL | + | ***Make sure ''Serial Receiver Provider'' is set to '''''SPEKTRUM2040/SRXL''''' |
| − | ***Now in other features, '''set''' the ''TELEMETRY'' slider to '''ON'''. | + | ***Now in other features, '''set''' the ''TELEMETRY'' slider to '''''ON'''''. |
| − | **On the '''Receiver''' page, make sure your ''Channel Map'' is set to '''TAER1234''' (SPEKTRUM) | + | **On the '''Receiver''' page, make sure your ''Channel Map'' is set to '''''TAER1234''''' (SPEKTRUM) |
*You should now have Telemetry, and you can use your transmitters instructions and settings to display and alarm as desired. | *You should now have Telemetry, and you can use your transmitters instructions and settings to display and alarm as desired. | ||
Revision as of 13:11, 19 June 2019
Under Construction
Spektrum Telemetry
- Easy to setup (really just the third pin plug and telemetry slider in configurator) and provides the following Data:
- Provided by Rx, Fades, Frames, Holds
- Provided by Betaflight/FLEXF3:
- Main Battery Pack (Main 3S) Voltage
- Virtual (estimated) Current
- Virtual (estimated) Capacity used (fuel totalizer)
- Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T
- Bind the receiver to the transmitter
- Connect to FLEXF3 using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers)
- Use your configuration tool to:
- On Configuration page
- Make sure Receiver Mode is set to a serial based receiver.
- Make sure Serial Receiver Provider is set to SPEKTRUM2040/SRXL
- Now in other features, set the TELEMETRY slider to ON.
- On the Receiver page, make sure your Channel Map is set to TAER1234 (SPEKTRUM)
- On Configuration page
- You should now have Telemetry, and you can use your transmitters instructions and settings to display and alarm as desired.
