Difference between revisions of "Cypher/Telemetry"
From Flex Innovations Wiki
| Line 11: | Line 11: | ||
*Bind the receiver to the transmitter | *Bind the receiver to the transmitter | ||
*Connect to '''FLEXF3''' using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers) | *Connect to '''FLEXF3''' using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers) | ||
| − | *Use your configuration tool to: | + | *Use your configuration tool to: (hit the pages 'Save' button before leavng each page) |
**On '''Configuration''' page | **On '''Configuration''' page | ||
***Make sure ''Receiver Mode'' is set to a '''''serial based receiver'''''. | ***Make sure ''Receiver Mode'' is set to a '''''serial based receiver'''''. | ||
Revision as of 13:13, 19 June 2019
Under Construction
Spektrum Telemetry
- Easy to setup (really just the third pin plug and telemetry slider in configurator) and provides the following Data:
- Provided by Rx, Fades, Frames, Holds
- Provided by Betaflight/FLEXF3:
- Main Battery Pack (Main 3S) Voltage
- Virtual (estimated) Current
- Virtual (estimated) Capacity used (fuel totalizer)
- Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T
- Bind the receiver to the transmitter
- Connect to FLEXF3 using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers)
- Use your configuration tool to: (hit the pages 'Save' button before leavng each page)
- On Configuration page
- Make sure Receiver Mode is set to a serial based receiver.
- Make sure Serial Receiver Provider is set to SPEKTRUM2040/SRXL
- Now in Other Features, set the TELEMETRY slider to ON.
- On the Receiver page, make sure your Channel Map is set to TAER1234 (SPEKTRUM)
- On Configuration page
- You should now have Telemetry, and you can use your transmitters instructions and settings to display and alarm as desired.
