Difference between revisions of "Cypher/Telemetry"

Revision as of 13:17, 19 June 2019

Under Construction

Easy to setup (really just the third pin plug and telemetry slider in configurator) and provides the following Data:
- Provided by Rx:
  - Fades (frames lost by individual sub-Rx)
  - Frames (frames of data lost buy all combined Rx)
  - Holds (Failsafe caused buy more than 40 continuous Frame losses)
  - Some may provide Rx bus voltage, 4649T appears to not provide it
- Provided by Betaflight/FLEXF3:
  - Main Battery Pack (Main 3S) Voltage
  - Virtual (estimated) Current
  - Virtual (estimated) Capacity used (fuel totalizer)
Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T
Bind the receiver to the transmitter
Connect to FLEXF3 using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers)
Use your configuration tool to: (hit the pages 'Save' button before leavng each page)
- On Configuration page
  - Make sure Receiver Mode is set to a serial based receiver.
  - Make sure Serial Receiver Provider is set to SPEKTRUM2040/SRXL
  - Now in Other Features, set the TELEMETRY slider to ON.
- On the Receiver page, make sure your Channel Map is set to TAER1234 (SPEKTRUM)
You should now have Telemetry, and you can use your transmitters instructions and settings to display and alarm as desired.

@@ Line 3: / Line 3: @@
 ===Spektrum Telemetry===
 *Easy to setup (really just the third pin plug and telemetry slider in configurator) and provides the following Data:
-**Provided by '''Rx''', Fades, Frames, Holds (some may provide Rx bus voltage, 4649T appears to not provide it)
+**Provided by '''Rx''':
+***Fades (frames lost by individual sub-Rx)
+***Frames (frames of data lost buy all combined Rx)
+***Holds (Failsafe caused buy more than 40 continuous Frame losses)
+***Some may provide Rx bus voltage, 4649T appears to not provide it
 **Provided by '''Betaflight/FLEXF3''':
 ***Main Battery Pack (Main 3S) Voltage