Difference between revisions of "Cypher/Telemetry"
From Flex Innovations Wiki
| Line 2: | Line 2: | ||
===Spektrum Telemetry=== | ===Spektrum Telemetry=== | ||
| − | *Easy to setup | + | *Easy to setup (really just the plug and telemetry slider in configurator) and provides the following Data: |
| + | **Provided by Rx, Fades, Frames, Holds | ||
| + | **Provided by Betaflight/FLEXF3: | ||
| + | ***Main Battery Pack (Main 3S) Voltage | ||
| + | ***Virtual (estimated) Current | ||
| + | ***Virtual (estimated) Capacity used (fuel totalizer) | ||
*Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T | *Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T | ||
*Bind the receiver to the transmitter | *Bind the receiver to the transmitter | ||
Revision as of 13:09, 19 June 2019
Under Construction
Spektrum Telemetry
- Easy to setup (really just the plug and telemetry slider in configurator) and provides the following Data:
- Provided by Rx, Fades, Frames, Holds
- Provided by Betaflight/FLEXF3:
- Main Battery Pack (Main 3S) Voltage
- Virtual (estimated) Current
- Virtual (estimated) Capacity used (fuel totalizer)
- Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T
- Bind the receiver to the transmitter
- Connect to FLEXF3 using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers)
- Use your configuration tool to:
- On Configuration page
- Make sure Receiver Mode is set to a serial based receiver.
- Make sure Serial Receiver Provider is set to SPEKTRUM2040/SRXL
- Now in other features, set the TELEMETRY slider to ON.
- On the Receiver page, make sure your Channel Map is set to TAER1234 (SPEKTRUM)
- On Configuration page
- You should now have Telemetry, and you can use your transmitters instructions and settings to display and alarm as desired.
