Cypher/Telemetry
From Flex Innovations Wiki
Under Construction
Spektrum Telemetry
- Easy to setup (really just the third pin plug and telemetry slider in configurator) and provides the following Telemetry Data:
- Provided by Rx:
- Fades (frames lost by individual sub-Rx)
- Frames (frames of data lost buy all combined Rx)
- Holds (Failsafe caused buy more than 40 continuous Frame losses)
- Some may provide Rx bus (BEC) voltage, 4649T appears to not provide it
- Provided by Betaflight/FLEXF3:
- Main Battery Pack (Main 3S) Voltage
- Virtual (estimated) Current
- Virtual (estimated) Capacity used (fuel totalizer)
- Provided by Rx:
- Choose a telemetry capable receiver such as the AR4649T (Preferred) or AR8010T
- Bind the receiver to the transmitter
- Connect to FLEXF3 using the first 3 pins (-,+,signal). (Use 3-male to 3-mail pin cable if required for AR8010T style receivers)
- Use your configuration tool to: (hit the pages 'Save' button before leavng each page)
- On Configuration page
- Make sure Receiver Mode is set to a serial based receiver.
- Make sure Serial Receiver Provider is set to SPEKTRUM2040/SRXL
- Now in Other Features, set the TELEMETRY slider to ON.
- On the Receiver page, make sure your Channel Map is set to TAER1234 (SPEKTRUM)
- On Configuration page
- You should now have Telemetry, and you can use your transmitters instructions and settings to display and alarm as desired.