Difference between revisions of "F-100D 90mm EDF/ProFlapSetup"
From Flex Innovations Wiki
(Created page with " --Under Construction--") |
|||
Line 2: | Line 2: | ||
--Under Construction-- | --Under Construction-- | ||
+ | |||
+ | {{DISPLAYTITLE:F-100D Super Sabre 90mm EDF Latest Updates, Build Tips and Addendum}} | ||
+ | |||
+ | == Pro Tips for Flap Setup == | ||
+ | |||
+ | === Notes === | ||
+ | ====Center of Gravity==== | ||
+ | *The CG section of the F-100D manual had some conflicting information displayed. The correct CG's are listed in the image to the right. Click for the full sized image. | ||
+ | ====JR DMSS Use==== | ||
+ | *In addition to the JR DMSS receivers listed in the manual, the '''RG812BX''' should be a good choice as well. Avoid the '''BPX''' receivers as they will not do servo pulses and serial data at the same time. | ||
+ | *We recommend updating to the very latest Aura Firmware '''v1.14''' or higher and then set the 'new to Aura' '''JR XBUS MODE A''' serial data in the transmitter and the Aura. | ||
+ | *Using '''MODE A''', you can physically wire/connect it just like Futaba diagram in the manual (P. 7). Throttle and Gear in the Receivers ports. Xbus to Port B in Aura. | ||
+ | |||
+ | === Setup === | ||
+ | |||
+ | == TBD == | ||
+ | |||
+ | |||
+ | <noinclude> | ||
+ | [[Category:SuperPNP|Super PNP]] | ||
+ | [[Category:F-100D_90mm_EDF|F-100D_90mm_EDF]] | ||
+ | </noinclude> |
Revision as of 15:54, 30 August 2020
--Under Construction--
Contents
Pro Tips for Flap Setup
Notes
Center of Gravity
- The CG section of the F-100D manual had some conflicting information displayed. The correct CG's are listed in the image to the right. Click for the full sized image.
JR DMSS Use
- In addition to the JR DMSS receivers listed in the manual, the RG812BX should be a good choice as well. Avoid the BPX receivers as they will not do servo pulses and serial data at the same time.
- We recommend updating to the very latest Aura Firmware v1.14 or higher and then set the 'new to Aura' JR XBUS MODE A serial data in the transmitter and the Aura.
- Using MODE A, you can physically wire/connect it just like Futaba diagram in the manual (P. 7). Throttle and Gear in the Receivers ports. Xbus to Port B in Aura.