Difference between revisions of "QQExtra300/G2ServoAddendum"

From Flex Innovations Wiki
Jump to: navigation, search
Line 7: Line 7:
 
*'''Connect''' your Extra's Aura to the Aura Config Tool. '''Read''' the Settings from Aura and '''File->Save''' them to a folder on your PC for backup.
 
*'''Connect''' your Extra's Aura to the Aura Config Tool. '''Read''' the Settings from Aura and '''File->Save''' them to a folder on your PC for backup.
 
*[http://www.resources.flexinnovations.com/files/QQ_Extra_300_G2_DS15V2.acf '''Download this new Aura Config File'''] and '''File->Save''' it you a folder on your PC. (You may need to ''right-click'' the link and ''Save Link (or Target) As'')
 
*[http://www.resources.flexinnovations.com/files/QQ_Extra_300_G2_DS15V2.acf '''Download this new Aura Config File'''] and '''File->Save''' it you a folder on your PC. (You may need to ''right-click'' the link and ''Save Link (or Target) As'')
*'''File-->Open''' the new Aura Config File in the Config Tool.  
+
*'''File-->Open''' the new Aura Config File you just downloaded in the Aura Config Tool.  
 
*On the '''Settings''' Tab, set your '''Transmitter Type''' and '''Receiver Connection''' fields.
 
*On the '''Settings''' Tab, set your '''Transmitter Type''' and '''Receiver Connection''' fields.
 
*With the Aura still Connected '''Write All''' to Aura.
 
*With the Aura still Connected '''Write All''' to Aura.

Revision as of 16:34, 19 July 2019

We made improvements to the DS15 Servo used in the Extra G2, but the roll-out of the servo was not properly controlled at the assembly line.
Because of this, a small quantity of Extra's with improved servos were shipped without the matching updates to the Aura Settings.


If your Extra feels like the gains are too high, please follow the procedure below to update your Aura Settings.

  • Connect your Extra's Aura to the Aura Config Tool. Read the Settings from Aura and File->Save them to a folder on your PC for backup.
  • Download this new Aura Config File and File->Save it you a folder on your PC. (You may need to right-click the link and Save Link (or Target) As)
  • File-->Open the new Aura Config File you just downloaded in the Aura Config Tool.
  • On the Settings Tab, set your Transmitter Type and Receiver Connection fields.
  • With the Aura still Connected Write All to Aura.


NOTE: If you have manually set Aura Subtrims, or have previously done a QUICK TRIM, You can Open your back-up of your old settings and go through the Servo Ports (S1-S8) and make a NOTE of the Subtrim value in each port. You can then Read your new settings from Aura and enter these values in the Servo Ports->Subtrim and Write them to Aura. (Make sure you set View->Advanced View)