Difference between revisions of "QQExtra300/G2ServoAddendum"

From Flex Innovations Wiki
Jump to: navigation, search
Line 13: Line 13:
  
 
'''NOTE:''' If you have manually set Aura '''Subtrims''', or have previously done a '''QUICK TRIM''', You can '''Open''' your back-up of your old settings and go through the '''Servo Ports''' (S1-S8) and make a NOTE of the '''Subtrim''' value in each port. You can then '''Read''' your new settings from Aura and enter these values in the '''Servo Ports->Subtrim''' and '''Write''' them to Aura. (Make sure you set '''View->Advanced View''')
 
'''NOTE:''' If you have manually set Aura '''Subtrims''', or have previously done a '''QUICK TRIM''', You can '''Open''' your back-up of your old settings and go through the '''Servo Ports''' (S1-S8) and make a NOTE of the '''Subtrim''' value in each port. You can then '''Read''' your new settings from Aura and enter these values in the '''Servo Ports->Subtrim''' and '''Write''' them to Aura. (Make sure you set '''View->Advanced View''')
 +
 +
 +
'''NOTE:'''  If '''replacing servos''' with newly ordered ones after early July 2019, you will need to load the new configuration file.

Revision as of 17:26, 19 July 2019

We made improvements to the DS15 Servo used in the Extra G2, but the roll-out of the servo was not properly controlled at the assembly line.
Because of this, a small quantity of Extra's with improved servos were shipped without the matching updates to the Aura Settings.


If your Extra feels like the gains are too high, then install our newest Aura configuration for the QQ Extra 300 G2.

  • Connect your Extra's Aura to the Aura Config Tool. Read the settings from Aura and File->Save them to a folder on your PC for backup.
  • Download this new Aura Config File and File->Save it you a folder on your PC. (You may need to right-click the link and Save Link (or Target) As)
  • File-->Open the new Aura Config File you just downloaded in the Aura Config Tool.
  • On the Settings Tab, set your Transmitter Type and Receiver Connection fields.
  • With the Aura still Connected Write All to Aura.


NOTE: If you have manually set Aura Subtrims, or have previously done a QUICK TRIM, You can Open your back-up of your old settings and go through the Servo Ports (S1-S8) and make a NOTE of the Subtrim value in each port. You can then Read your new settings from Aura and enter these values in the Servo Ports->Subtrim and Write them to Aura. (Make sure you set View->Advanced View)


NOTE: If replacing servos with newly ordered ones after early July 2019, you will need to load the new configuration file.