Difference between revisions of "RV-8 60E G2/Crow"
From Flex Innovations Wiki
(Created page with "{{DISPLAYTITLE:How to Setup your RV-8 60E G2 Transmitter}} __FORCETOC__ <!-- This forces the Table of Contents since it has less than 3 levels --> == Crow Quick Set Procedure...") |
(No difference)
|
Revision as of 22:45, 30 June 2023
Contents
Crow Quick Set Procedure for RV-8 60E G2
To enter Quick Set mode, the Aura must receive a valid signal from the Receiver when the Aura is powered up.
Make sure your Transmitter is setup with your CH8/Aux3 channel assigned to a 2 Position switch for Crow.
Step 1 - Enter Quick Set mode
- Make sure all power is off on the RV-8 60E G2
- Remove the prop before making changes
- Turn on your transmitter
- Remove the Servo lead from Aura Port S2.
- Put a bind plug in Aura Port S2.
- Plug in the battery to power up the RV-8 60E G2
- The Orange LED will be OFF while the Green LED is ON indicating you are in the Quick Set mode and receiving a valid signal from the Receiver.
Step 2 - Choose Crow Option
After entering Quick Set mode as described above, toggle the CH8/Aux3 channel switch on the transmitter to ENABLE or DISABLE the Crow functionality.
- If the Red LED is on SOLID, Crow option is ENABLED in the Aura.
- If the Red LED is OFF, the Crow option is DISABLED in the Aura.
Step 3 - Save the desired Crow Option
- After correctly toggling the CH8/Aux3 switch to Enable or Disable the Crow option, remove the bind plug save the settings.
- The LEDs will turn on while the Aura is saving, then will go back to their previous state.
- Completely power off the RV-8 and Aura
- Replace the Servo Lead in Aura Port S2
- Power up, confirm that the Crow option can be be activated with your CH8/Aux3 Switch and Fly!