Difference between revisions of "Template:Aura/OpenTX/oldestFirmwareText"
From Flex Innovations Wiki
m |
m |
||
| Line 1: | Line 1: | ||
| − | |||
| − | |||
| − | |||
== Choose an option below to proceed: == | == Choose an option below to proceed: == | ||
Revision as of 22:51, 17 November 2021
Contents
Choose an option below to proceed:
Create a new Transmitter model using our pre-configured Transmitter model file
- We STRONGLY recommend downloading our pre-configured FrSky Transmitter Model File.
- After downloading the FrSky Transmitter Model File, copy it to your FrSky SD Card, and use the 'Restore Model' function on a blank slot of the 'Model Selection' menu in your Transmitter.
- This will create a Transmitter model named 'aura' with the appropriate transmitter settings.
- This correctly sets up your OpenTX transmitter's Futaba SBUS channel order, travel limits, directions, and centers.
- NOTE: The Aura will Auto-Detect the transmitter as Futaba rather than FrSky or OpenTX.
Modify an Existing Transmitter model
If you already have an existing FrSky Transmitter model you would like to use, additional details are provided below to update the model to work well with Aura.
- In the 'INPUTS' menu:
- Create a "Ch5/Gear" Input and assign it to a 3 position switch such as Switch SE.
- Create a "Ch6/Aux1" Input and assign it to a 3 position switch such as Switch SB.
- Create a "Ch7/Aux2" Input and assign it to a 3 position switch such as Switch SC.
- Create a "Ch8/Aux4" Input and assign it to a 3 position switch such as Knob S2.
- In the 'MIXER' menu:
- Adjust the Channel order on the 'MIXER' menu to Ail, Ele, Thr, Rudder, Ch5/Gear, Ch6/Aux1, Ch7/Aux2, Ch8/Aux3.
- In the 'OUTPUT' menu:
- Reduce the travel limit on the throttle channel to 84%.
- Ail, Ele, and Rud should have travel limits of 100%.
- Reverse the direction of the Elevator and Throttle on the 'OUTPUT' menu.
- set the "PPM Center" setting to 1530 so the stick's centered value matches the default Futaba standard for Ail, Ele, and Rudder on the 'OUTPUT' menu.
Verify your FrSky Transmitter File is setup correctly
You can confirm your FrSky transmitter is setup correctly using the Aura Config Tool.
- Open the Aura Config Tool, connect to the Aura over USB and turn on Live Data.
- On the "Setup Tab" of the Aura Config Tool, scroll down to the 'Input Monitor and Transmitter Verification' box.
- Confirm that the graphics move and match your transmitter movements.
- Confirm in the Input Monitor that Aura is reading "0%" with the sticks centered and +/- 125% on the Aileron/Elevator/Rudder channels.
