Difference between revisions of "Ventique60e/BuildTips"
From Flex Innovations Wiki
m |
|||
| Line 13: | Line 13: | ||
*'''Ventique Manual''' in [http://store.flexinnovations.com/s/Ventique_60e_Assembly_Manual_English.pdf '''English'''] and [http://store.flexinnovations.com/s/9712370_German_Manual_V2.PDF '''German'''] | *'''Ventique Manual''' in [http://store.flexinnovations.com/s/Ventique_60e_Assembly_Manual_English.pdf '''English'''] and [http://store.flexinnovations.com/s/9712370_German_Manual_V2.PDF '''German'''] | ||
| + | |||
| + | <noinclude>[[Category:Ventique60e|Ventique 60e]]</noinclude> | ||
Revision as of 01:36, 29 March 2017
- Please review Ventique Addendum with Building tips.
- There have been a couple of reports of the set screws coming loose in the Potenza 60 470kv Motor. During the build, please remove the shaft set screws one at a time from the bell housing (flange) and the shaft retaining collar, apply 242 loctite, and tighten them securely. Motor instructions with images can be seen here
- Ventique Aura Installation Instructions
- Mount the Aura oriented as shown on the Platform behind the wing tube with two-sided tape and secure with a hook-and-loop strap.
- Fabricate a plywood or balsa diagonal brace from the platform to the former near the floor to stiffen the mounting platform, otherwise, you will have significant vibration feedback into the gyro sensors.
- The Aura Config File for the Ventique can be easily built in the New Aura Config File "Wizard" by selecting the "Aura Config Type: Ventique", and then choosing the other details of your setup in the Wizard.
- Alternately, you can Download a Ventique .acf file
- After you setup is complete, secure the Aura with a hook-and-loop strap
