https://wiki.flexinnovations.com/index.php?action=history&feed=atom&title=RV-8_10E_G2%2FCrow 2026-04-22T12:05:19Z Revision history for this page on the wiki MediaWiki 1.25.2 https://wiki.flexinnovations.com/index.php?title=RV-8_10E_G2/Crow&diff=6054&oldid=prev 2025-08-06T22:45:27Z

<p>Created page with &quot;{{DISPLAYTITLE:How to Enable/Disable the Crow Switch using Quick Set from your Transmitter}} __FORCETOC__ &lt;!-- This forces the Table of Contents since it has less than 3 level...&quot;</p> <p><b>New page</b></p><div>{{DISPLAYTITLE:How to Enable/Disable the Crow Switch using Quick Set from your Transmitter}}<br /> __FORCETOC__ &lt;!-- This forces the Table of Contents since it has less than 3 levels --&gt;<br /> == Crow Quick Set Procedure for RV-8 10E G2 ==<br /> <br /> To enter Quick Set mode, the Aura must receive a valid signal from the Receiver when the Aura is powered up.<br /> <br /> Make sure your Transmitter is setup with your CH8/Aux3 channel assigned to a 2 Position switch for Crow.<br /> <br /> === Step 1 - Enter Quick Set mode ===<br /> # Make sure all power is off on the RV-8 10E G2<br /> #* Remove the prop before making changes with Quick Set<br /> # Turn on your transmitter<br /> # Remove the Servo lead from Aura Port S2.<br /> # Put a bind plug in Aura Port S2.<br /> # Plug in the battery to power up the RV-8 10E G2<br /> # The Orange LED will be OFF while the Green LED is ON indicating you are in the Quick Set mode and receiving a valid signal from the Receiver.<br /> <br /> === Step 2 - Choose Crow Option ===<br /> After entering Quick Set mode as described above, toggle the CH8/Aux3 channel switch on the transmitter to ENABLE or DISABLE the Crow functionality.<br /> # If the Red LED is ON, the Crow option is ENABLED in the Aura.<br /> # If the Red LED is OFF, the Crow option is DISABLED in the Aura.<br /> <br /> === Step 3 - Save the desired Crow Option ===<br /> # After correctly toggling the CH8/Aux3 switch to Enable or Disable the Crow option, '''remove the bind plug save the settings'''.<br /> # The LEDs will turn on while the Aura is saving, then will go back to their previous state.<br /> # Completely power off the RV-8 and Aura<br /> # Replace the Servo Lead in Aura Port S2<br /> # Power up, confirm that the Crow option can be activated with the CH8/Aux3 Switch and Fly!<br /> <br /> &lt;noinclude&gt;<br /> [[Category:SuperPNP|Super PNP]]<br /> [[Category:RV8|RV-8]]<br /> &lt;/noinclude&gt;</div>

WikiSys