RV-8 60E G2/GyroGainKill - Revision history

WikiSys at 22:54, 30 June 2023

2023-06-30T22:54:13Z

2023-06-30T22:51:30Z

@@ Line 8: / Line 8: @@
 === Step 1 - Enter Quick Set mode ===
-* Make sure all power is off on the RV-8 60E G2
+# Make sure all power is off on the RV-8 60E G2
-** Remove the prop before making changes
+#* Remove the prop before making changes with Quick Set
-* Turn on your transmitter
+# Turn on your transmitter
-* Remove the Servo lead from Aura Port S2.
+# Remove the Servo lead from Aura Port S2.
-* Put a bind plug in Aura Port S2.
+# Put a bind plug in Aura Port S2.
-* Plug in the battery to power up the RV-8 60E G2
+# Plug in the battery to power up the RV-8 60E G2
-* The Orange LED will be OFF while the Green LED is ON indicating you are in the Quick Set mode and receiving a valid signal from the Receiver.
+# The Orange LED will be OFF while the Green LED is ON indicating you are in the Quick Set mode and receiving a valid signal from the Receiver.
 === Step 2 - Choose Gyro Gain Kill Switch Option ===
 After entering Quick Set mode as described above, toggle the CH7/Aux2 channel switch on the transmitter to ENABLE or DISABLE the Gyro Gain Kill switch.
-* If the Blue LED is ON, the Gyro Gain Kill switch option is ENABLED in the Aura.
+# If the Blue LED is ON, the Gyro Gain Kill switch option is ENABLED in the Aura.
-* If the Blue LED is OFF, the Gyro Gain Kill switch option is DISABLED in the Aura.
+# If the Blue LED is OFF, the Gyro Gain Kill switch option is DISABLED in the Aura.
 === Step 3 - Save the Gyro Gain Kill Switch Option ===

@@ Line 1: / Line 1: @@
 {{DISPLAYTITLE:How to Enable/Disable the Gyro Gain Switch using Quick Set from your Transmitter}}
 __FORCETOC__ <!-- This forces the Table of Contents since it has less than 3 levels -->
-== Gyro Gain Kill sSitch Quick Set Procedure for RV-8 60E G2 ==
+== Gyro Gain Kill Switch Quick Set Procedure for RV-8 60E G2 ==
 To enter Quick Set mode, the Aura must receive a valid signal from the Receiver when the Aura is powered up.