https://wiki.flexinnovations.com/index.php?action=history&feed=atom&title=Ventique_60E_G2%2FGyroGainKill 2026-04-16T03:27:00Z Revision history for this page on the wiki MediaWiki 1.25.2 https://wiki.flexinnovations.com/index.php?title=Ventique_60E_G2/GyroGainKill&diff=6079&oldid=prev 2025-08-07T00:49:28Z

<p>Created page with &quot;{{DISPLAYTITLE:How to Enable/Disable the Gyro Gain Switch using Quick Set from your Transmitter}} __FORCETOC__ &lt;!-- This forces the Table of Contents since it has less than 3...&quot;</p> <p><b>New page</b></p><div>{{DISPLAYTITLE:How to Enable/Disable the Gyro Gain Switch using Quick Set from your Transmitter}}<br /> __FORCETOC__ &lt;!-- This forces the Table of Contents since it has less than 3 levels --&gt;<br /> == Gyro Gain Kill Switch Quick Set Procedure for Ventique 60E G2 Pro ==<br /> <br /> To enter Quick Set mode, the Aura must receive a valid signal from the Receiver when the Aura is powered up.<br /> <br /> Make sure your Transmitter is setup with your CH7/Aux2 channel assigned to a 2 Position switch for the Gyro Gain Kill switch.<br /> <br /> === Step 1 - Enter Quick Set mode ===<br /> # Make sure all power is off on the Airplane<br /> #* Remove the prop before making changes with Quick Set<br /> # Turn on your transmitter<br /> # Remove the Servo lead from Aura Port S2.<br /> # Put a bind plug in Aura Port S2.<br /> # Plug in the battery to power up the Airplane<br /> # The Orange LED will be OFF while the Green LED is ON indicating you are in the Quick Set mode and receiving a valid signal from the Receiver.<br /> <br /> === Step 2 - Choose Gyro Gain Kill Switch Option ===<br /> After entering Quick Set mode as described above, toggle the CH7/Aux2 channel switch on the transmitter to ENABLE or DISABLE the Gyro Gain Kill switch.<br /> # If the Blue LED is ON, the Gyro Gain Kill switch option is ENABLED in the Aura.<br /> # If the Blue LED is OFF, the Gyro Gain Kill switch option is DISABLED in the Aura.<br /> <br /> === Step 3 - Save the Gyro Gain Kill Switch Option ===<br /> # After correctly toggling the CH7/Aux2 switch to Enable or Disable the Gyro Gain Kill switch option, '''remove the bind plug save the settings'''.<br /> # The LEDs will turn on while the Aura is saving, then will go back to their previous state.<br /> # Completely power off the Airplane and Aura<br /> # Replace the Servo Lead in Aura Port S2<br /> # Power up, confirm that the Gyro Gain Kill switch can kill the Gyro Gain with the CH7/Aux2 Switch and Fly!<br /> <br /> &lt;noinclude&gt;<br /> [[Category:SuperPNP|Super PNP]]<br /> [[Category:Ventique_60E_G2|Ventique 60E G2 Pro]]<br /> &lt;/noinclude&gt;</div>

WikiSys