Difference between revisions of "FlexJetPro90/AuraFiles"
From Flex Innovations Wiki
(→Aura Files and Help) |
(→Aura Files and Help) |
||
Line 5: | Line 5: | ||
**[http://www.resources.flexinnovations.com/aura/auraConfigFiles/FlexJetPro_Aura_Pro_Generic.acf '''FlexJet Pro File for Aura Professionals'''] | **[http://www.resources.flexinnovations.com/aura/auraConfigFiles/FlexJetPro_Aura_Pro_Generic.acf '''FlexJet Pro File for Aura Professionals'''] | ||
− | *General | + | *Transmitter Setting Tips when using Aura |
+ | **As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap | ||
+ | ***Flaperon mixing will be done by Aura | ||
+ | **CH5 is reserved for Retract Use (Rx Port) | ||
+ | **CH6 is is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available. | ||
+ | |||
+ | |||
+ | *General Aura guidelines for File Use. | ||
**Download the appropriate file for your Aura and move it to a known directory on your PC | **Download the appropriate file for your Aura and move it to a known directory on your PC | ||
**Open the Aura Config Tool (update tool if update is available) | **Open the Aura Config Tool (update tool if update is available) |
Revision as of 18:32, 13 August 2020
Aura Files and Help
- Click a link below to Download the Aura Config file
- Transmitter Setting Tips when using Aura
- As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
- Flaperon mixing will be done by Aura
- CH5 is reserved for Retract Use (Rx Port)
- CH6 is is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available.
- As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
- General Aura guidelines for File Use.
- Download the appropriate file for your Aura and move it to a known directory on your PC
- Open the Aura Config Tool (update tool if update is available)
- Please make sure your Aura Firmware is v1.14 or newer
- Open the Aura Config File (.acf) from the saved location.
- On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
- Save your file.
- Write all to Aura
- Power up and adjust settings in Servo Ports as needed
- Reversing may be needed depending on Servo Brand, etc.
- Subtrim will likely be needed.
- You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally