Difference between revisions of "FlexJetPro90/AuraFiles"
From Flex Innovations Wiki
(→Aura Files and Help) |
(→Transmitter Setting Tips when using Aura) |
||
| Line 12: | Line 12: | ||
| − | + | ==General Aura guidelines for File Use.== | |
| − | + | *Download the appropriate file for your Aura and move it to a known directory on your PC | |
| − | + | *Open the Aura Config Tool (update tool if update is available) | |
| − | + | **Please make sure your Aura Firmware is v1.14 or newer | |
| − | + | *Open the Aura Config File (.acf) from the saved location. | |
| − | + | *On the ''Setup Tab'', select your Radio Brand and Protocol and Connection Port. | |
| − | + | *''Save'' your file. | |
| − | + | *''Write all to Aura'' | |
| − | + | *Power up and adjust settings in ''Servo Ports'' as needed | |
| − | + | **''Reversing'' may be needed depending on Servo Brand, etc. | |
| − | + | **''Subtrim'' will likely be needed. | |
| − | + | **You can tweak ''Output Scale'' (travel) as needed to make surfaces move symmetrically/equally | |
Revision as of 18:33, 13 August 2020
Contents
Aura Files and Help
Click a link below to Download the Aura Config file
Transmitter Setting Tips when using Aura
- As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
- Flaperon mixing will be done by Aura
- CH5 is reserved for Retract Use (Rx Port)
- CH6 is is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available.
General Aura guidelines for File Use.
- Download the appropriate file for your Aura and move it to a known directory on your PC
- Open the Aura Config Tool (update tool if update is available)
- Please make sure your Aura Firmware is v1.14 or newer
- Open the Aura Config File (.acf) from the saved location.
- On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
- Save your file.
- Write all to Aura
- Power up and adjust settings in Servo Ports as needed
- Reversing may be needed depending on Servo Brand, etc.
- Subtrim will likely be needed.
- You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally
