Difference between revisions of "FlexJetPro90/AuraFiles"
From Flex Innovations Wiki
(→Aura Files and Help) |
(→Aura Files and Help) |
||
| Line 5: | Line 5: | ||
**[http://www.resources.flexinnovations.com/aura/auraConfigFiles/FlexJetPro_Aura_Pro_Generic.acf '''FlexJet Pro File for Aura Professionals'''] | **[http://www.resources.flexinnovations.com/aura/auraConfigFiles/FlexJetPro_Aura_Pro_Generic.acf '''FlexJet Pro File for Aura Professionals'''] | ||
| − | * | + | *General instructions for File Use. |
| + | **Download the appropriate file for your Aura and move it to a known directory on your PC | ||
| + | **Open the Aura Config Tool (update tool if update is available) | ||
| + | ***Please make sure your Aura Firmware is v1.14 or newer | ||
| + | **Open the Aura Config File (.acf) from the saved location. | ||
| + | **On the ''Setup Tab'', select your Radio Brand and Protocol and Connection Port. | ||
| + | **''Save'' your file. | ||
| + | **''Write all to Aura'' | ||
| + | **Power up and adjust settings in ''Servo Ports'' as needed | ||
| + | ***''Reversing'' may be needed depending on Servo Brand, etc. | ||
| + | ***''Subtrim'' will likely be needed. | ||
| + | ***You can tweak ''Output Scale'' (travel) as needed to make surfaces move symmetrically/equally | ||
| + | |||
| + | |||
* [http://wiki.flexinnovations.com/wiki/Aura General Aura Information] | * [http://wiki.flexinnovations.com/wiki/Aura General Aura Information] | ||
Revision as of 18:28, 13 August 2020
Aura Files and Help
- Click a link below to Download the Aura Config file
- General instructions for File Use.
- Download the appropriate file for your Aura and move it to a known directory on your PC
- Open the Aura Config Tool (update tool if update is available)
- Please make sure your Aura Firmware is v1.14 or newer
- Open the Aura Config File (.acf) from the saved location.
- On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
- Save your file.
- Write all to Aura
- Power up and adjust settings in Servo Ports as needed
- Reversing may be needed depending on Servo Brand, etc.
- Subtrim will likely be needed.
- You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally
