Difference between revisions of "TwinOtter 80E/Crow"
From Flex Innovations Wiki
m |
m |
||
Line 30: | Line 30: | ||
<noinclude> | <noinclude> | ||
[[Category:SuperPNP|Super PNP]] | [[Category:SuperPNP|Super PNP]] | ||
− | [[Category:TwinOtter|Twin Otter | + | [[Category:TwinOtter|Twin Otter]] |
</noinclude> | </noinclude> |
Latest revision as of 00:38, 1 July 2023
Contents
Crow Quick Set Procedure for Twin Otter 80E
To enter Quick Set mode, the Aura must receive a valid signal from the Receiver when the Aura is powered up.
Make sure your Transmitter is setup with your CH8/Aux3 channel assigned to a 2 Position switch for Crow.
Step 1 - Enter Quick Set mode
- Make sure all power is off on the Twin Otter 80E
- Remove the prop before making changes with Quick Set
- Turn on your transmitter
- Remove the Servo lead from Aura Port S2.
- Put a bind plug in Aura Port S2.
- Plug in the battery to power up the Twin Otter
- The Orange LED will be OFF while the Green LED is ON indicating you are in the Quick Set mode and receiving a valid signal from the Receiver.
Step 2 - Choose Crow Option
After entering Quick Set mode as described above, toggle the CH8/Aux3 channel switch on the transmitter to ENABLE or DISABLE the Crow functionality.
- If the Red LED is ON, the Crow option is ENABLED in the Aura.
- If the Red LED is OFF, the Crow option is DISABLED in the Aura.
Step 3 - Save the desired Crow Option
- After correctly toggling the CH8/Aux3 switch to Enable or Disable the Crow option, remove the bind plug save the settings.
- The LEDs will turn on while the Aura is saving, then will go back to their previous state.
- Completely power off the Twin Otter and Aura
- Replace the Servo Lead in Aura Port S2
- Power up, confirm that the Crow option can be activated with the CH8/Aux3 Switch and Fly!