Aura Files and Help

Click a link below to Download the Aura Config file

As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
- Flaperon mixing will be done by Aura
CH5 is reserved for Retract Use (Rx Port)
CH6 is is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available.

Download the appropriate file for your Aura and move it to a known directory on your PC
Open the Aura Config Tool (update tool if update is available)
- Please make sure your Aura Firmware is v1.14 or newer
Open the Aura Config File (.acf) from the saved location.
On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
Save your file.
Write all to Aura
Power up and adjust settings in Servo Ports as needed
- Reversing may be needed depending on Servo Brand, etc.
- Subtrim will likely be needed.
- You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally