FlexJetPro90/AuraFiles
From Flex Innovations Wiki
Revision as of 18:37, 13 August 2020 by FlexTeam (Talk | contribs) (→Transmitter Setting Tips when using Aura)
Contents
Aura Files and Help
Click a link below to Download the Aura Config file
Transmitter Setting Tips when using Aura
- As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
- Flaperon mixing will be done by Aura
- CH5 is reserved for Retract Use via Receiver Port)
- CH6 is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available.
- CH8 is reserved for Master Gain (but is NOT enabled in Control Modes
- CH9 is used for Flight Mode Change (Could be changed to CH7 for example on Setup Tab
General Aura guidelines for File Use.
- Download the appropriate file for your Aura and move it to a known directory on your PC
- Open the Aura Config Tool (update tool if update is available)
- Please make sure your Aura Firmware is v1.14 or newer
- Open the Aura Config File (.acf) from the saved location.
- On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
- Save your file.
- Write all to Aura
- Power up and adjust settings in Servo Ports as needed
- Reversing may be needed depending on Servo Brand, etc.
- Subtrim will likely be needed.
- You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally