FlexJetPro90/AuraFiles

Aura Files and Help

Click a link below to Download the Aura Config file

• • FlexJet Pro File for Standard Aura 8
  • FlexJet Pro File for Aura Professionals

Transmitter Setting Tips when using Aura

• As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
  • Flaperon mixing will be done by Aura
• CH5 is reserved for Retract Use (Rx Port)
• CH6 is is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available.

• General Aura guidelines for File Use.
  • Download the appropriate file for your Aura and move it to a known directory on your PC
  • Open the Aura Config Tool (update tool if update is available)
    • Please make sure your Aura Firmware is v1.14 or newer
  • Open the Aura Config File (.acf) from the saved location.
  • On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
  • Save your file.
  • Write all to Aura
  • Power up and adjust settings in Servo Ports as needed
    • Reversing may be needed depending on Servo Brand, etc.
    • Subtrim will likely be needed.
    • You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally

• General Aura Information

Product Information

• FlexJet Pro 90mm EDF Product Page