How to Setup your Transmitter for the Ventique 60E G2 Pro
From Flex Innovations Wiki
Revision as of 20:48, 6 August 2025 by WikiSys (Talk | contribs) (Created page with "{{DISPLAYTITLE:How to Setup your Transmitter for the Ventique 60E G2 Pro}} __FORCETOC__ <!-- This forces the Table of Contents since it has less than 3 levels --> == Transmitt...")
Transmitter Model Setup Procedure
- Create a Blank Transmitter Airplane Model with 1 Throttle, 1 Aileron, 1 Elevator, 1 Rudder and any Flaps or Flap System OFF.
- Assign the Transmitter's Ch5/Gear channel to a 3 Position switch to change the Flight Modes in flight
- (Optional) Assign the Transmitter's Ch7/Aux2 Channel to a 2 Position switch to function as a Gyro Gain Kill switch in flight
- The Gyro Gain Kill functionality is initially Disabled by default, but can be Enabled using Quick Set with your Transmitter
- Adjust Aileron, Elevator, Rudder and Throttle End Points (aka Travel Limits or ATV) as shown in the table below for your Transmitter brand
- Verify the rest of the settings as shown in the table below for your Transmitter brand
| Spektrum, Futaba, JR & Graupner | FrSky | Jeti (EX-Bus) | |
|---|---|---|---|
| Wing/Tail Type | 1 Aileron, 1 Elevator, 1 Rudder | 1 Aileron, 1 Elevator, 1 Rudder | 1 Aileron, 1 Elevator, 1 Rudder |
| End Points (Travel Adjust or ATV) | Ail/Ele/Rud: 125% | Ail/Ele/Rud: 100% | Ail/Ele/Rud: 100% |
| Throttle End Points (Travel Adjust or ATV) | Thr: 100% | Thr: 84% | Thr: 80% |
| Reversing | Not Allowed | ||
| Sub-Trim | Verify at Zero, NOT ALLOWED | ||
| Trim Levers | Verify at Zero | ||
| Flight Mode Switch: CH5/Gear | Assign the CH5/Gear channel to a 3 Position switch | ||
| Gyro Gain Kill Switch: CH7/Aux2** | Assign the CH7/Aux2 channel to a 2 Position switch (Optional) | ||
| First Flight Timer | For your first flight, set to 4:00 | ||
** - The Gyro Gain Kill Switch is initially Disabled and can be Enabled using Quick Set from your Transmitter as detailed below
