FV-31 Cypher Wiki
From Flex Innovations Wiki
Welcome to the Flex Innovations - FV-31 Cypher Wiki
Contents
- 1 FV-31 Cypher
- 1.1 Aircraft Info
- 1.2 Manuals and Documents
- 1.3 Product Information
- 1.4 Configuration Tools for Betaflight
- 1.5 Use a Configuration Tool to Set or Reset the Angle/Six Axis Level
- 1.6 Troubleshoot ARMING Difficulties
- 1.7 Entire Betaflight Wiki here for reference
- 1.8 Enabling Telemetry
- 1.9 Optional Electronic Adjustments
- 1.10 Power and Accessory Notes
FV-31 Cypher
Aircraft Info
Manuals and Documents
- Instruction Manual (English)
Product Information
CAUTION: You must disconnect all motors, or securely restrain your Cypher when making and/or testing configuration changes
Configuration Tools for Betaflight
Use a Configuration Tool to Set or Reset the Angle/Six Axis Level
- NOTE: The wing leveling six axis mode is named ANGLE mode in Betaflight lingo.
- Place your Cypher on a level surface. Check that wings are level. You may want to shim the nosewheel up 2-5mm to set a more positive angle. (The angle relates to trim speed and can be set to taste).
- Connect to your configuration tool and navigate to the Setup page.
- With the Cypher level per above, click the Calibrate Accelerometer button.
- Note the settings are now zeroed out. You are finished. Disconnect.
Troubleshoot ARMING Difficulties
- Click this link to see notes on trouble shooting including a complete list of Prevention Flag Meanings
- Review notes at link above for Betaflight 3.5
- Note your Cypher's Arming Disable Flags using the Betaflight Configurator on the Setup page in the Info box at right.
- Some common (beep code) Examples:
- (2) FAILSAFE - Rx signal indicates Failsafe
- (3) RXLOSS - No valid Rx signal found - Check Tx and Rx on and bound and connected
- (7) THROTTLE - Throttle too high - lower throttle
- (8) ANGLE - Cypher must be level within 25 degrees to arm
- (13) CLI - CLI mode is active - Exit CLI and/or Disconnect configurator
- (17) MSP - Connected to configurator - Disconnect
Entire Betaflight Wiki here for reference
- Click this link for the Betaflight Wiki
- Note that FV-31 Cypher code is based on Betaflight version 3.5. It is unique code, and it is not possible to build it with the 'generic source code'.
- Note that the FLEXF3 Board/PCBA is hardware specifically developed by Flex Innovations for the FV-31 Cypher.
Enabling Telemetry
Optional Electronic Adjustments
Power and Accessory Notes
CAUTION: You must disconnect all motors, or securely restrain your Cypher when making and/or testing configuration changes