Difference between revisions of "Cypher/BuildTips"
From Flex Innovations Wiki
(→Angle Mode Calibration) |
|||
| Line 1: | Line 1: | ||
===Build Tips=== | ===Build Tips=== | ||
| − | The manual does not cover installing the wheels on the axles. | + | *The manual does not cover installing the wheels on the axles. |
| − | *Place a wheel onto the axle | + | **Place a wheel onto the axle |
| − | *Apply blue thread lock to the set screw | + | **Apply blue thread lock to the set screw |
| − | *Install wheel collar and snug with the included 1.5mm hex driver | + | **Install wheel collar and snug with the included 1.5mm hex driver |
<br /> | <br /> | ||
| − | Page 26, step to should read: | + | *Page 26, step to should read: |
| − | 2. | + | :2. Once the vertical fins have dried, use a #1 Phillips screwdriver and the screws removed from the tilt setup section to secure the rear hatch assembly onto the fuselage. Note that the two shorter '''''larger diameter''''' screws are used front mount locations. |
<br /> | <br /> | ||
Revision as of 14:28, 9 September 2019
Build Tips
- The manual does not cover installing the wheels on the axles.
- Place a wheel onto the axle
- Apply blue thread lock to the set screw
- Install wheel collar and snug with the included 1.5mm hex driver
- Page 26, step to should read:
- 2. Once the vertical fins have dried, use a #1 Phillips screwdriver and the screws removed from the tilt setup section to secure the rear hatch assembly onto the fuselage. Note that the two shorter larger diameter screws are used front mount locations.
Angle Mode Calibration
Please Calibrate the accelerometer before first flights!
Key adjustments before first flight for smooth transitions! Set per manual:
- Adjust fan angle with gauges for 45 degree/Magic -and- 0 degree/Forward Flight. Adjust hover fan angle.
- Adjust elevon angles with gauge.
- Check CG
