Difference between revisions of "Cypher/GraupnerInput"
(→Reversing) |
(→Reversing) |
||
| Line 59: | Line 59: | ||
</pre> | </pre> | ||
<br /> | <br /> | ||
| − | NOTE: You can check by rotating the virtual 'body' on the Receiver Page of Configurator | + | NOTE: You can check 'reversing' by rotating the virtual 'body' on the Receiver Page of the Configurator |
==== Travel ==== | ==== Travel ==== | ||
Revision as of 18:23, 10 August 2019
Contents
Setup for using a Graupner HOTT Tx/Rx
Always start with a reset/new transmitter model!
NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the Graupner Rx to the FLEXF3. This is the same cable arrangement shown on page 15 of the manual for the Futaba connections. (Non-Telemetry)
CYPHER/Betaflight Settings
Use one of the Betaflight configuration tools to make these settings. Be sure to SAVE the configuration page after adjustments.
Configuration Page
Receiver Mode -> Serial Based Receiver (Cypher Default) Serial Receiver Provider -> SUMD (aka Graupner SUMD) Telemetry slider -> OFF (Cypher Default)
SAVE the page!
CLI Page
Channel Order -> TAER1234 (Cypher Default) To set, in your configurator, go to the 'CLI' page.
Graupner Transmitter settings:
MX16 Mode 2 transmitter used for validations
(Most common models expected to work the SAME)
Receiver with diversity and SUMD out capability recommended.
You can verify the completed settings using the tools using the BetaFlight Receiver page.
Setup
Name: Cypher Model Type: Plane/Acro Wing type: 1 Ail, 0 Flaps (default) Tail type: Normal 1 Elev 1 Rudd (default) Throttles: 1 (default) The rest are defaults (default) Assign a 2-position switch to CH5/Gear (Stability/Angle Mode) Assign a 3-position switch to CH6/Aux1 (Configuration/Tilt) Bind your Transmitter and Receiver Set your system to output SUMD of 8 No Subtrim should be used
Reversing
1 Throttle => 2 Aileron <= 3 Elevator => 4 Rudder <= 5 Gear => -or as desired 6 Aux1 <= -or as desired
NOTE: You can check 'reversing' by rotating the virtual 'body' on the Receiver Page of the Configurator
Travel
1 Throttle +-125% 2 Aileron +-125% 3 Elevator +-125% 4 Rudder +-125% 5 Profile-Stab +-125% 6 Config-Tilt +100 -60% To Start-Must adjust with gauges!
Go to the Receiver Page in Configurator and fine tune Aileron,Elevator, and Rudder travel to 1000-1500-2000. (See notes on top of Configurator page)
Timers
Set a count down
Timer length suggestion for first flights
2200mAh: 2:30
2600mAh: 3:10
3300mAh: 4:00
