Difference between revisions of "FlexJet/LatestUpdates"
From Flex Innovations Wiki
(→Build Tips) |
|||
Line 11: | Line 11: | ||
== Build Tips == | == Build Tips == | ||
*When using the new '''"T" Spektrum Receivers''' such as the AR8010T, the Aura needs to be '''Firmware 1.6''' to establish connection via SRXL as noted on our AR8010T page. | *When using the new '''"T" Spektrum Receivers''' such as the AR8010T, the Aura needs to be '''Firmware 1.6''' to establish connection via SRXL as noted on our AR8010T page. | ||
− | * | + | *Aura also must to be up to date (FW 1.6) for Dual Spektrum Remote Receiver handling. |
<br /> | <br /> | ||
NOTE: All FlexJets purchased in North America ship with FW 1.6 installed | NOTE: All FlexJets purchased in North America ship with FW 1.6 installed |
Revision as of 13:39, 28 March 2018
Latest Updates
Printed Manual Typo
None
Latest Online Manual
The Latest Version of the Flex Jet (Rev - 1.0) is available online.
- This version matches the printed manual.
Build Tips
- When using the new "T" Spektrum Receivers such as the AR8010T, the Aura needs to be Firmware 1.6 to establish connection via SRXL as noted on our AR8010T page.
- Aura also must to be up to date (FW 1.6) for Dual Spektrum Remote Receiver handling.
NOTE: All FlexJets purchased in North America ship with FW 1.6 installed
- Tips
- It is possible to scrape the ventral fins and tail cone on the ground on landing. You can put a couple of layers of clear tape on the bottom of these to reduce wear
- It is likely that you ventral fins are already installed, so you may not have to install these per the manual.
- Your Side Fairings behind the stab are likely NOT installed. The are likely packed with your missile rails. Please glue them onto the aft fuselage with CA or Epoxy.
Please consult the Flex Jet Manual for Build instructions.
Addendum
None at this time.