Difference between revisions of "FlexJet/LatestUpdates"
From Flex Innovations Wiki
(→Build Tips) |
(→Printed Manual Typo) |
||
| Line 3: | Line 3: | ||
== Latest Updates == | == Latest Updates == | ||
=== Printed Manual Typo === | === Printed Manual Typo === | ||
| − | None | + | None - See below |
=== Latest Online Manual === | === Latest Online Manual === | ||
Revision as of 13:42, 28 March 2018
Latest Updates
Printed Manual Typo
None - See below
Latest Online Manual
The Latest Version of the Flex Jet (Rev - 1.0) is available online.
- This version matches the printed manual.
Build Tips
- When using the new "T" Spektrum Receivers such as the AR8010T, the Aura needs to be Firmware 1.6 to establish connection via SRXL as noted on our AR8010T page.
- Aura also must to be up to date (FW 1.6) for Dual Spektrum Remote Receiver handling.
- Per the manual insert, please set you CH5/Gear Travel to +-125% to ensure the gear sequencer will follow the transmitter commands properly.
NOTE: All FlexJets purchased in North America ship with FW 1.6 installed
- Tips
- It is possible to scrape the ventral fins and tail cone on the ground on landing. You can put a couple of layers of clear tape on the bottom of these to reduce wear
- It is likely that you ventral fins are already installed, so you may not have to install these per the manual.
- Your Side Fairings behind the stab are likely NOT installed. The are likely packed with your missile rails. Please glue them onto the aft fuselage with CA or Epoxy.
Please consult the Flex Jet Manual for Build instructions.
Addendum
None at this time.
