Difference between revisions of "FlexJetPro90/AuraFiles"
From Flex Innovations Wiki
(→General Aura guidelines for File Use.) |
(→Transmitter Setting Tips when using Aura) |
||
| Line 8: | Line 8: | ||
*As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap | *As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap | ||
**Flaperon mixing will be done by Aura | **Flaperon mixing will be done by Aura | ||
| − | *CH5 is reserved for ''Retract'' Use via Receiver Port) | + | *CH5 is reserved for ''Retract'' Use via Receiver Port (set 2-position switch) |
| − | *CH6 is the ''Flap'' 'data' that '''Aura''' will Mix into Flaperons. Use land system if available. | + | *CH6 is the ''Flap'' 'data' that '''Aura''' will Mix into Flaperons. Use land system if available. (set 3 (or 2) position switch) |
| − | *CH8 is reserved for ''Master Gain'' (but is NOT enabled in ''Control Modes'' | + | *CH8 is reserved for ''Master Gain'' (but is NOT enabled in ''Control Modes'' (set proportional knob or slider if desired, and enable in Control Modes) |
| − | *CH9 is used for ''Flight Mode Change'' (Could be changed to CH7 for example on ''Setup Tab'' | + | *CH9 is used for ''Flight Mode Change'' (Could be changed to CH7 for example on ''Setup Tab'' (set 3-position switch) |
==General Aura guidelines for File Use.== | ==General Aura guidelines for File Use.== | ||
Revision as of 18:42, 13 August 2020
Contents
Aura Files and Help
Click a link below to Download the Aura Config file
Transmitter Setting Tips when using Aura
- As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
- Flaperon mixing will be done by Aura
- CH5 is reserved for Retract Use via Receiver Port (set 2-position switch)
- CH6 is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available. (set 3 (or 2) position switch)
- CH8 is reserved for Master Gain (but is NOT enabled in Control Modes (set proportional knob or slider if desired, and enable in Control Modes)
- CH9 is used for Flight Mode Change (Could be changed to CH7 for example on Setup Tab (set 3-position switch)
General Aura guidelines for File Use.
- Download the appropriate file for your Aura and move it to a known directory on your PC
- Open the Aura Config Tool (update tool if update is available)
- Please make sure your Aura Firmware is v1.14 or newer
- Open the Aura Config File (.acf) from the saved location.
- On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
- Verify that the Orientation of the Aura is as-set on the Setup Tab, Adjust as needed.
- Save your file.
- Write all to Aura
- Power up and adjust settings in Servo Ports as needed
- Reversing may be needed depending on Servo Brand, etc.
- Subtrim will likely be needed.
- You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally
- Perform and pass all Control and Sensor Tests
