Mamba Electric Conversion
From Flex Innovations Wiki
Mamba Electric Conversion
The Mamba was designed with electric conversion in mind. The aircraft has designed in a forward hatch that makes access to batteries and connectors easy. The 'fuel tank tray' is located to work as a basis for a battery Tray/Mount.
Flight time of this relatively light 12S 6200mAh setup is about 4-4.5 minutes with proper throttle management and a good reserve. Make first flights about 2/3 of this time and check remainin capacity while breaking in and balancing your packs.
The primary conversion is strengthening the 'fuel tank tray' to work as a 'battery tray'.
Power System (as demonstrated by Flex Innovations)
- E-Flite 360 - 180kv Motor(EFLM4360A)
- The chosen motor uses the same bolt pattern and firewall hole locations as a DA Gas Engine making mounting easy.
- The Prop bolt pattern also matches the DA 4-bolt pattern.
- 70mm total motor standoffs
- Potenza 5000 6S 60C batteries were used (Two in series (12S))
- Castle 160HV ESC
- Mejzlik 25 x 12S Prop
Reinforced the Battery Tray
Thin and medium CA Glue was used for all. See Images
- Approximately 1/2 wide strips of Carbon plate (~.080" thick) was used in two places to reinforce the structure under the tray. It was wrapped to the structure with carbon chord (tow).
- At the aft end under the battery tray oriented vertically. Carbon chord wraps used.
- At the middle of the tray oriented flat against the bottom of the tray. Carbon chord wraps used.
- Two strips of Carbon plate were laminated to the top of the tray to stiffen it and to apply velcro® to.
- The aft edge of the plates were thinned to allow carbon chord wraps to be applied to prevent delamination.
- A hole were made in the front center of each plate, and the plated was wrapped to the existing structure with carbon chord to prevent delamination.
- Holes and slots were made in the tray to allow for carbon wraps, and velcro® straps