Difference between revisions of "Mamba10/ServoAddendum"

Revision as of 20:08, 30 July 2019

We made improvements to the DS-15 Servo used in the Mamba 10, but the roll-out of the servo was not properly controlled at the assembly line.
Because of this, a small quantity of Mamba 10's with improved servos were shipped without the matching updates to the Aura Settings.

If your Mamba 10 feels like the gains are too high (typically indicated by in-flight oscillation or excessive "bouncing" after hard stops), then install our newest Aura configuration for the Mamba 10.

• Connect your Mamba's Aura to the Aura Config Tool. Read the settings from Aura and File->Save them to a folder on your PC for backup.
• New, Stock Aura Profile
  • Right-Click and Save As the new Aura Config File to a folder on your PC.
• New, Stock - Crow Aura Profile
  • Right-Click and Save As the new Aura Config File to a folder on your PC.
• New, Expert Aura Profile
  • Right-Click and Save As the new Aura Config File to a folder on your PC.
• New, Expert - Crow Aura Profile
  • Right-Click and Save As the new Aura Config File to a folder on your PC.

• File-->Open the new Aura Config File you just downloaded in the Aura Config Tool.
• On the Settings Tab, set your Transmitter Type and Receiver Connection fields.
• With the Aura still Connected Write All to Aura.

NOTE: If you have manually set Aura Subtrims, or have previously done a QUICK TRIM, You can Open your back-up of your old settings and go through the Servo Ports (S1-S8) and make a NOTE of the Subtrim value in each port. You can then Read your new settings from Aura and enter these values in the Servo Ports->Subtrim and Write them to Aura. (Make sure you set View->Advanced View)

NOTE: If replacing servos with newly ordered (DS-15 V2) ones after early July 2019, you will need to load the new configuration file.

Right-Click to Save As the new Extra Aura Config File