Difference between revisions of "RV-8 60E G2/Crow"

From Flex Innovations Wiki
Jump to: navigation, search
(Created page with "{{DISPLAYTITLE:How to Setup your RV-8 60E G2 Transmitter}} __FORCETOC__ <!-- This forces the Table of Contents since it has less than 3 levels --> == Crow Quick Set Procedure...")
(No difference)

Revision as of 22:45, 30 June 2023


Crow Quick Set Procedure for RV-8 60E G2

To enter Quick Set mode, the Aura must receive a valid signal from the Receiver when the Aura is powered up.

Make sure your Transmitter is setup with your CH8/Aux3 channel assigned to a 2 Position switch for Crow.

Step 1 - Enter Quick Set mode

  • Make sure all power is off on the RV-8 60E G2
    • Remove the prop before making changes
  • Turn on your transmitter
  • Remove the Servo lead from Aura Port S2.
  • Put a bind plug in Aura Port S2.
  • Plug in the battery to power up the RV-8 60E G2
  • The Orange LED will be OFF while the Green LED is ON indicating you are in the Quick Set mode and receiving a valid signal from the Receiver.

Step 2 - Choose Crow Option

After entering Quick Set mode as described above, toggle the CH8/Aux3 channel switch on the transmitter to ENABLE or DISABLE the Crow functionality.

  • If the Red LED is on SOLID, Crow option is ENABLED in the Aura.
  • If the Red LED is OFF, the Crow option is DISABLED in the Aura.

Step 3 - Save the desired Crow Option

  1. After correctly toggling the CH8/Aux3 switch to Enable or Disable the Crow option, remove the bind plug save the settings.
  2. The LEDs will turn on while the Aura is saving, then will go back to their previous state.
  3. Completely power off the RV-8 and Aura
  4. Replace the Servo Lead in Aura Port S2
  5. Power up, confirm that the Crow option can be be activated with your CH8/Aux3 Switch and Fly!
Retrieved from "https://wiki.flexinnovations.com/index.php?title=RV-8_60E_G2/Crow&oldid=5836"