Difference between revisions of "Ventique60e/BuildTips"
From Flex Innovations Wiki
Line 3: | Line 3: | ||
*Please review [http://www.resources.flexinnovations.com/files/9712370-_Ventique_Addendum.pdf '''Ventique Addendum'''] with Building tips. | *Please review [http://www.resources.flexinnovations.com/files/9712370-_Ventique_Addendum.pdf '''Ventique Addendum'''] with Building tips. | ||
− | *There have been a couple of reports of the '''set screws coming loose''' in the Potenza 60 470kv Motor. During the build, please remove the shaft set screws one at a time from the bell housing (flange) and the retaining collar, apply 242 loctite, and tighten them securely. | + | *There have been a couple of reports of the '''set screws coming loose''' in the Potenza 60 470kv Motor. During the build, please remove the shaft set screws one at a time from the bell housing (flange) and the shaft retaining collar, apply 242 loctite, and tighten them securely. Motor instructions can be [http://www.resources.flexinnovations.com/files/Potenza_60_Instructions_ENG.pdf '''seen here'''] |
*Ventique '''Aura Installation Instructions'''[[File:Ventique Aura 600h.png|thumb|upright=0.5|right|Reinforce the Tray]] | *Ventique '''Aura Installation Instructions'''[[File:Ventique Aura 600h.png|thumb|upright=0.5|right|Reinforce the Tray]] |
Revision as of 16:08, 9 August 2016
- Please review Ventique Addendum with Building tips.
- There have been a couple of reports of the set screws coming loose in the Potenza 60 470kv Motor. During the build, please remove the shaft set screws one at a time from the bell housing (flange) and the shaft retaining collar, apply 242 loctite, and tighten them securely. Motor instructions can be seen here
- Ventique Aura Installation Instructions
- Mount the Aura oriented as shown on the Platform behind the wing tube with two-sided tape and secure with a hook-and-loop strap.
- Fabricate a plywood or balsa diagonal brace from the platform to the former near the floor to stiffen the mounting platform, otherwise, you will have vibration feedback into the gyro sensors.
- The Aura Config File for the Ventique can be easily built in the New Aura Config File "Wizard" by selecting the "Aura Config Type: Ventique", and then choosing the other details of your setup in the Wizard.
- Alternately, you can Download a Ventique .acf file