Difference between revisions of "Cypher/JetiInput"
From Flex Innovations Wiki
(→Setup for using a Jeti Tx/Rx) |
(→Setup for using a Jeti Tx/Rx) |
||
| Line 5: | Line 5: | ||
=== Cypher/Betaflight Settings === | === Cypher/Betaflight Settings === | ||
Configuration Page | Configuration Page | ||
| − | *Receiver Mode -> Serial Based Receiver | + | *Receiver Mode -> Serial Based Receiver (Cypher Default) |
*Serial Receiver Provide -> JETIEXBUS | *Serial Receiver Provide -> JETIEXBUS | ||
| − | *Telemetry slider is OFF ( | + | *Telemetry slider is OFF (Cypher Default - Unless configuring with telemetry based on those supplementary instructions) |
Receiver Page | Receiver Page | ||
| − | *Channel Order -> TAER1234 (Same as Spektrum) | + | *Channel Order -> TAER1234 (Cypher Default - Same as Spektrum) |
Revision as of 19:16, 9 August 2019
Contents
Setup for using a Jeti Tx/Rx
Always start with a reset/new transmitter model!
Cypher/Betaflight Settings
Configuration Page
- Receiver Mode -> Serial Based Receiver (Cypher Default)
- Serial Receiver Provide -> JETIEXBUS
- Telemetry slider is OFF (Cypher Default - Unless configuring with telemetry based on those supplementary instructions)
Receiver Page
- Channel Order -> TAER1234 (Cypher Default - Same as Spektrum)
Transmitter settings:
do this
Some third party links on using Jeti with Betaflight:
https://github.com/betaflight/betaflight/issues/167
https://github.com/betaflight/betaflight/blob/master/docs/Telemetry.md
https://www.drone-zone.de/anleitung-jeti-ex-telemetrie-mit-betaflight/ ***
https://www.rcgroups.com/forums/showthread.php?2530376-Multirotor-Controller-Setup
channel map, "TAER1234", which is Throttle, Aileron, Elevator, Rudder, Aux1 .. Aux4. This matches the default servo assignment that we just made.
https://www.rcgroups.com/forums/showpost.php?p=33054194&postcount=8
