Difference between revisions of "Cypher/JRDMSSInput"
From Flex Innovations Wiki
(Created page with "== '''Setup for using a Jeti Tx/Rx''' == <br /> Betaflight Provider Setting '''<big>Always start with a reset/new transmitter...") |
(→Setup for using a Jeti Tx/Rx) |
||
Line 1: | Line 1: | ||
− | == '''Setup for using a | + | == '''Setup for using a JR DMSS Tx/Rx''' == |
<br /> | <br /> | ||
[[File:Jeti Rx Set.png|thumb|upright=0.42|right|Betaflight Provider Setting]] | [[File:Jeti Rx Set.png|thumb|upright=0.42|right|Betaflight Provider Setting]] | ||
'''<big>Always start with a reset/new transmitter model!</big>''' | '''<big>Always start with a reset/new transmitter model!</big>''' | ||
<br /> | <br /> | ||
− | NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the | + | NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the JR DMSS Rx to the FLEXF3. This is the same cable arrangement shown on page 15 of the manual for the Futaba connections. (Non-Telemetry) |
<br /> | <br /> | ||
=== CYPHER/Betaflight Settings === | === CYPHER/Betaflight Settings === | ||
Line 12: | Line 12: | ||
<pre> | <pre> | ||
Receiver Mode -> Serial Based Receiver (Cypher Default) | Receiver Mode -> Serial Based Receiver (Cypher Default) | ||
− | Serial Receiver Provider -> | + | Serial Receiver Provider -> JR |
− | Telemetry slider -> OFF (Cypher Default | + | Telemetry slider -> OFF (Cypher Default) |
− | + | ||
</pre> | </pre> | ||
− | ''''' | + | '''''CLI Page''''' |
<pre> | <pre> | ||
− | Channel Order -> | + | Channel Order -> AER2T134 Must be set in CLI Mode!! |
</pre> | </pre> | ||
<br /> | <br /> |
Revision as of 16:47, 10 August 2019
Setup for using a JR DMSS Tx/Rx
Always start with a reset/new transmitter model!
NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the JR DMSS Rx to the FLEXF3. This is the same cable arrangement shown on page 15 of the manual for the Futaba connections. (Non-Telemetry)
CYPHER/Betaflight Settings
Use one of the Betaflight configuration tools to make these settings. Be sure to SAVE the page after adjustments.
Configuration Page
Receiver Mode -> Serial Based Receiver (Cypher Default) Serial Receiver Provider -> JR Telemetry slider -> OFF (Cypher Default)
CLI Page
Channel Order -> AER2T134 Must be set in CLI Mode!!
JETI Transmitter settings:
DS-16 Mode 2 transmitter and R3 EX RSW Receiver used for validations
(Most common models expected to work the SAME)
You can verify the completed settings using the tools using the BetaFlight Receiver page.
Model->New Model
Name: FV-31 Cypher Model Type: Aero
Bind to Rx per Jeti instructions (verify function with servo in port 2 if desired)
Model->Basic Properties
Name: FV-31 Cypher Wing type: 0 Flaps, 1 Ail Tail type: Normal 1H1V (default) Engine count: 1 (default) The rest are defaults (default)