Cypher/JRDMSSInput

Setup for using a JR DMSS Tx/Rx

Always start with a reset/new transmitter model!
NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the JR DMSS Rx to the FLEXF3. This is the same cable arrangement shown on page 15 of the manual for the Futaba connections. (Non-Telemetry)

CYPHER/Betaflight Settings

Use one of the Betaflight configuration tools to make these settings. Be sure to SAVE the page after adjustments.

Configuration Page

Betaflight Serial Provider Setting

Betaflight Channel Map Setting

Receiver Mode            ->  Serial Based Receiver (Cypher Default)
Serial Receiver Provider ->  XBUS_MODE_B           (aka JR XBUS MODE B)
Telemetry slider         ->  OFF                   (Cypher Default)

CLI Page

Channel Order            ->  AER2T134  Must be set in CLI Mode!!

Go to the '''CLI''' page.
Cut and paste or type the following line into the command line:
   map AER2T134
Hit ENTER on the keyboard than type:
   save
Hit ENTER on the keyboard. (This is NOT the 'Save to File' button)[[File:JR_MAP_Check.png|thumb|upright=0.42|right|Betaflight JR Map Check]]

You can VERIFY (but not pick) the AER2T134 settings on the Receiver Page.

JETI Transmitter settings:

DS-16 Mode 2 transmitter and R3 EX RSW Receiver used for validations (Most common models expected to work the SAME)
You can verify the completed settings using the tools using the BetaFlight Receiver page.

Model->New Model

Name:                  FV-31 Cypher
Model Type:            Aero

Bind to Rx per Jeti instructions (verify function with servo in port 2 if desired)

Model->Basic Properties

Name:                  FV-31 Cypher
Wing type:             0 Flaps, 1 Ail
Tail type:             Normal 1H1V        (default)
Engine count:          1                  (default)
The rest are defaults                     (default)