Cypher/JRDMSSInput
Setup for using a JR DMSS Tx/Rx
Always start with a reset/new transmitter model!
NOTE: If your JR transmitter is DMSS, continue here. If it is DSM2 or DSMX, follow Spektrum instructions!
NOTE: You will use the 3-Pin to 4-Pin Male to Male cable provided to connect the JR DMSS Rx to the FLEXF3. This is the same cable arrangement shown on page 15 of the manual for the Futaba connections. (Non-Telemetry)
CYPHER/Betaflight Settings
Use one of the Betaflight configuration tools to make these settings. Be sure to SAVE the configuration page after adjustments.
Receiver Mode -> Serial Based Receiver (Cypher Default) Serial Receiver Provider -> XBUS_MODE_B (aka JR XBUS MODE B) Telemetry slider -> OFF (Cypher Default)
SAVE the page!
CLI Page
Channel Order -> AER2T134 Must be set in CLI Mode for JR DMSS!! Go to the 'CLI' page. Cut and paste or type the following line into the command line: map AER2T134 Hit ENTER on the keyboard than paste or type: save Hit ENTER on the keyboard. (This is NOT the 'Save to File' button)
You can VERIFY (but not pick) the AER2T134 settings on the Receiver Page.
JR DMSS Transmitter settings:
XG14 Mode 2 transmitter and R?? Receiver used for validations
(Most common models expected to work the SAME)
You can verify the completed settings using the tools using the BetaFlight Receiver page.
Model->New Model
Name: FV-31 Cypher Model Type: Aero
Bind to Rx per Jeti instructions (verify function with servo in port 2 if desired)
Setup
Wing type: 1 Ail, 0 Flaps (default) Tail type: Normal 1 Elev 1 Rudd (default) Throttles: 1 (default) The rest are defaults (default) Assign a 2-position switch to CH5/Gear (Stability/Angle Mode) Assign a 3-position switch to CH6/Aux1 (Configuration/Tilt)
Reversing
1 Ailerons R (Reversed) 2 Elevator N 3 Rudder R (Reversed) 4 Throttle N 5 Gear N -or as desired 6 Aux1 N -or as desired
Model->Travel
1 Throttle +-88% ???? Verify from Tx 2 Aileron +-88% 3 Elevator +-88% 4 Rudder +-88% 5 Profile-Stab +-88% 6 Config-Tilt +70 -70% To Start-Must adjust with gauges!
Go to the Receiver Page in Configurator and fine tune AER to 1000-1500-2000
Model->Servo Setup
All items set to defaults except as notedDo the command and gyro checks
Model->Timers/Sensors
Timers: Set a count down Timer length suggestion for first flights 2200mAh: 2:30 2600mAh: 3:10 3300mAh: 4:00
Model->Device Explorer
With system powered and bound Under Receiver Example: R3 EX with ‘Check Mark’ Serial Link: EX Bus Note the JETIBOX/EX Bus Pin “Value” for plugging in Male to Male Cable. On the R3-EX it is “Ext” which is marked “4/EXT” on the receiver. The rest of settings are defaults/or as user desires Note: Output period shows 17ms