Difference between revisions of "FlexJetPro90/AuraFiles"
From Flex Innovations Wiki
(→Click a link below to Download the Aura Config file) |
(→General Aura Guidelines for File Use.) |
||
Line 28: | Line 28: | ||
**You can tweak ''Output Scale'' (travel) as needed to make surfaces move symmetrically/equally | **You can tweak ''Output Scale'' (travel) as needed to make surfaces move symmetrically/equally | ||
**'''Perform and pass all Control and Sensor Tests''' | **'''Perform and pass all Control and Sensor Tests''' | ||
+ | |||
+ | ==Aura Servo Port Assignments as seen in ''Servo Ports'' | ||
+ | *S1 Left Flaperon | ||
+ | *S2 Right Flaperon | ||
+ | *S3 Left Elevator | ||
+ | *S4 Right Elevator | ||
+ | *S5 Rudder | ||
+ | *S6 Nosewheel Steering | ||
+ | *S7 | ||
+ | *S8 | ||
===[http://wiki.flexinnovations.com/wiki/Aura General Aura Information]=== | ===[http://wiki.flexinnovations.com/wiki/Aura General Aura Information]=== |
Revision as of 18:47, 13 August 2020
Contents
Aura Files and Help
Click a link below to Download the Aura Config file
Transmitter Setting Tips when using Aura
- As always with Aura... Wing and Tail Type is Normal. 1 Aileron, 1 Elevator, 1 Rudder, 1 Flap
- Flaperon mixing will be done by Aura
- Use Receiver with working Throttle Port. Throttle is plugged into Receiver.
- CH5 is reserved for Retract Use via Receiver Port (set 2-position switch)
- CH6 is the Flap 'data' that Aura will Mix into Flaperons. Use land system if available. (set 3 (or 2) position switch)
- CH8 is reserved for Master Gain (but is NOT enabled in Control Modes (set proportional knob or slider if desired, and enable in Control Modes)
- CH9 is used for Flight Mode Change (Could be changed to CH7 for example on Setup Tab (set 3-position switch)
General Aura Guidelines for File Use.
- Download the appropriate file for your Aura and move it to a known directory on your PC
- Open the Aura Config Tool (update tool if update is available)
- Please make sure your Aura Firmware is v1.14 or newer
- Open the Aura Config File (.acf) from the saved location.
- On the Setup Tab, select your Radio Brand and Protocol and Connection Port.
- Verify that the Orientation of the Aura is as-set on the Setup Tab, Adjust as needed.
- Save your file.
- Write all to Aura
- Power up and adjust settings in Servo Ports as needed
- Reversing may be needed depending on Servo Brand, etc.
- Subtrim will likely be needed.
- You can tweak Output Scale (travel) as needed to make surfaces move symmetrically/equally
- Perform and pass all Control and Sensor Tests
==Aura Servo Port Assignments as seen in Servo Ports
- S1 Left Flaperon
- S2 Right Flaperon
- S3 Left Elevator
- S4 Right Elevator
- S5 Rudder
- S6 Nosewheel Steering
- S7
- S8