FlexJetPro90/AuraFiles/AdvancedAura

Advanced Aura Config Files

Since this is for advanced users, we will not go into great detail, but will instead present the file with some high level notes on its features and implementation!

• FlexJet Pro Advanced File for Standard Aura 8 for Electric FlexJet Pro's
• FlexJet Pro Advanced File for Aura Professional for Electric and Turbine FlexJet Pro's

Features

• Adds High Gain custom Nosewheel Steering gyro input via secondary control Mode E in gyro enabled modes!
• Nosewheel movement and gain is switched off when Gear is retracted!
• Add Transmitter independent TRIMMING to the Nosewheel Steering via Channel 10 Transmitter Channel Data! Once your model is quicktrimmed, you can still trim your nosewheel from the transmitter with optimum gyro conditions and no effect on the rudder!
• Most features and ports follow the same basis as the Normal Files

Hints on the new features!

• Channel 21 (CH21) is a copy of Tx Rudder data created with Input Remapping on the Setup Tab
  • CH21 is the Control Mode Input for YAW in Control Mode E. Pitch and Roll inputs are NONE.
  • Yaw Gain is set Very High in Control Mode E
  • Note Gain Scaling is Switched On/Off in Control Mode E by CH24 (see below)

Product Information

• FlexJet Pro 90mm EDF Product Page