Difference between revisions of "F-100D 90mm EDF/LatestUpdates"
From Flex Innovations Wiki
(→Care Tips) |
(→Addendums) |
||
Line 9: | Line 9: | ||
====Center of Gravity==== | ====Center of Gravity==== | ||
*The CG section of the F-100D manual had some conflicting information displayed. The correct CG's are listed in the image to the right. Click for the full sized image. | *The CG section of the F-100D manual had some conflicting information displayed. The correct CG's are listed in the image to the right. Click for the full sized image. | ||
+ | ====ESC Wires==== | ||
+ | *Check that the 3 ESC/Motor wires are fully plugged in. We recommend securing them with heat shrink or electrical tape to remove any chance they could be pulled loose. | ||
====Care Tips==== | ====Care Tips==== | ||
*As with all foam planes, and especially those with dark colors and cockpits, keep your plane out of direct sunlight (or cover it) when not flying! | *As with all foam planes, and especially those with dark colors and cockpits, keep your plane out of direct sunlight (or cover it) when not flying! |
Revision as of 23:44, 17 September 2020
Contents
Latest Updates
Latest Online Manual
The Latest Version of the F-100D Manual is available online.- This version matches the printed manual.
Addendums
Center of Gravity
- The CG section of the F-100D manual had some conflicting information displayed. The correct CG's are listed in the image to the right. Click for the full sized image.
ESC Wires
- Check that the 3 ESC/Motor wires are fully plugged in. We recommend securing them with heat shrink or electrical tape to remove any chance they could be pulled loose.
Care Tips
- As with all foam planes, and especially those with dark colors and cockpits, keep your plane out of direct sunlight (or cover it) when not flying!
- TIP: You can use a small drill bit or a #11 knife blade to make a small 2-3mm hole in the clear canopy above the ejection seat. This will reduce the temperatures a bit in the cockpit due to the 'greenhouse effect'.
- Use foam, a soft stand, or towels, or similar items to protect your models surface and finish when working on it, or transporting it!
JR DMSS Use
- In addition to the JR DMSS receivers listed in the manual, the RG812BX should be a good choice as well. Avoid the BPX receivers as they will not do servo pulses and serial data at the same time.
- We recommend updating to the very latest Aura Firmware v1.14 or higher and then set the 'new to Aura' JR XBUS MODE A serial data in the transmitter and the Aura.
- Using MODE A, you can physically wire/connect it just like Futaba diagram in the manual (P. 7). Throttle and Gear in the Receivers ports. Xbus to Port B in Aura.
- More information can be found in the Aura Brand Tips
Jeti EX Bus Use
- Note that EX Bus is now the preferred Jeti connection with Aura. More information can be found in the Aura Brand Tips
Spektrum SRXL2 Use
- Note that the AR6600T using SRXL2 is working with the Aura and F-100D. More information can be found in the Aura Brand Tips
Build Tips
- The Drop Tanks are fully assembled, no need to assemble the fins onto the tanks.