Difference between revisions of "Aura/JetiUse"

Revision as of 19:20, 27 June 2016

-Draft- Instructions for Using Jeti Duplex Systems with Aura AFCS

Feedback requested. Please send E-mail to Aura Support

This document will provide the instructions and reference materials:

• Click here for a pdf of general instructions notes, and reference material

We strongly recommend starting fresh with our Transmitter file for pre-configured setup of the channel data Aura Expects.These are the general purpose transmitter files for typical models (If the UDI settings do not come in autocratically, you can set them per the references in the PDF just above):

• Click here to download and Jeti Transmitter (.jsn) file for a Mode 2 Transmitter (throttle on left)
• Click here to download and Jeti Transmitter (.jsn) file for a Mode 1 Transmitter (throttle on right)

It is recommended that you use the New Aura Config File (Wizard) and create a model file specifically for your model. We do provide these files for Test/Reference however.

• Click here to download an Aura Config File for a typical sport/scale model
• Click here to download an Aura Config File for a typical 3D model

Some helpful links for Jeti Information and Firmware

• Jeti Firmware Page
• We are using the UDI Firmware Version for 16 channels in

UDI 16 R3/RSW-18US 3.24 (June, 2015)

• Or the Standard Firmware Version for 12 channels in

Standard R3/RSW-18US 3.24 (June, 2015)

NOTE: The special UDI 3.24 firmware allows Aura to see 16 Jeti Channels. the Normal 3.24 firmware will also work fine and allow Aura to see 12 Jeti Channels.

Check/Update your Jeti Receiver FW before continuing! Firmware 3.24 or higher is considered MANDATORY by Flex Innovations.