Difference between revisions of "Aura/JetiUse"
m |
|||
| Line 25: | Line 25: | ||
*[http://www.espritmodel.com/jeti-firmware-updates.aspx Jeti Firmware Page] | *[http://www.espritmodel.com/jeti-firmware-updates.aspx Jeti Firmware Page] | ||
| − | + | ||
| − | + | *[http://file.espritmodel.com/firmware/DEVUP2_Rx_324_UDI12%20Standard.zip Use the Standard Firmware Version for 12 channels in to Aura] | |
| − | *[http://file.espritmodel.com/firmware/DEVUP2_Rx_324_UDI12%20Standard.zip | + | |
Standard R3/RSW-18US 3.24 (June, 2015) | Standard R3/RSW-18US 3.24 (June, 2015) | ||
| − | NOTE: The special UDI 3.24 firmware | + | NOTE: The special UDI 3.24 firmware has a different Header ID byte and is not supported at this time. |
| − | Check/Update your Jeti Receiver FW before continuing! Firmware 3.24 or higher is considered MANDATORY by Flex Innovations. | + | Check/Update your Jeti Receiver FW before continuing! Firmware 3.24 (standard) or higher is considered MANDATORY by Flex Innovations. |
Revision as of 19:00, 30 June 2016
-Draft-
Instructions for Using Jeti Duplex Systems with Aura AFCS
Feedback requested. Please send E-mail to Aura Support
This document will provide the instructions and reference materials:
We strongly recommend starting fresh with our Transmitter file for pre-configured setup of the channel data Aura Expects.These are the general purpose transmitter files for typical models (If the UDI settings do not come in autocratically, you can set them per the references in the PDF just above):
- Click here to download and Jeti Transmitter (.jsn) file for a Mode 2 Transmitter (throttle on left)
- Click here to download and Jeti Transmitter (.jsn) file for a Mode 1 Transmitter (throttle on right)
It is recommended that you use the New Aura Config File (Wizard) and create a model file specifically for your model. We do provide these files for Test/Reference however.
- Click here to download an Aura Config File for a typical sport/scale model
- Click here to download an Aura Config File for a typical 3D model
Some helpful links for Jeti Information and Firmware
Standard R3/RSW-18US 3.24 (June, 2015)
NOTE: The special UDI 3.24 firmware has a different Header ID byte and is not supported at this time.
Check/Update your Jeti Receiver FW before continuing! Firmware 3.24 (standard) or higher is considered MANDATORY by Flex Innovations.
