Jeti Use - General Notes
Contents
Jeti Installation Notes
If you have any issues, successes or feedback regarding using Aura with Jeti, we'd love to get your feedback! Please send E-mail to Aura Support
Jeti Setup Notes
This document will provide the instructions and reference materials:
Remember Aura Expects one Aileron, one Elevator, and one Rudder signal along with a Flight Mode change Signal (as listed in the Reference Materials) to provide basic function.
Jeti Transmitter Files
Jeti Transmitters require more configuration than some other brands due to the several facts including that it does not have an 'always on' and dedicated serial data port, and because it shares an identical UDI/SRXL header byte (identifier code) with JR DMSS Mode B. Jeti is very flexible and powerful, but follows the European tradition of requiring the user to configure many things 'from scratch' (Examples: Flap System, Serial Output for specific Receiver).
We strongly recommend starting fresh with our transmitter file that provides a pre-configured setup of the channel data in the order, amount, and direction, etc Aura Expects. These are the general purpose transmitter files for typical models (If the UDI settings do not come in automatically, you can set them per the references in the PDF file just above) Load the appropriate file into your transmitter and select the model:
- Click here to download a Jeti Transmitter (.jsn) file for a Mode 2 Transmitter (throttle on left)
- Click here to download a Jeti Transmitter (.jsn) file for a Mode 1 Transmitter (throttle on right)
Note: When using these Transmitter Model Files, you should be able to simply Auto-Detect, Check, and Fly Flex Innovations PNP models like the Cessna 170 and QQ Extra. It works just like other supported brands using the Open Stock Quick Setup as well!
It is recommended that you use the New Aura Config File (Wizard) and create a model file specifically for your model. We do provide these files for Test/Reference however.
- Click here to download an Aura Config File for a typical sport/scale model
- Click here to download an Aura Config File for a typical 3D model
Helpful links for Jeti Information and Firmware
- Use this Standard Firmware Version for 12 channels in to Aura via UDI Standard R3/RSW-18US 3.24 (June, 2015)
- Jeti Firmware Page (reference)
NOTE: The special UDI 16 3.24 firmware has a different Header ID byte and is not supported at this time.
NOTE: The S.bus 3.24 firmware has not been tested and is not supported by Flex Innovations.
Check/Update your Jeti receiver firmware before continuing! Firmware 3.24 standard or higher is considered MANDATORY by Flex Innovations.