F-100D Super Sabre 90mm EDF Latest Updates, Build Tips and Addendum

--Under Construction--

Pro Tips for Flap Setup

Notes

Flap Notes

• There is no one 'right way' to setup flaps. This page will give an example of setting up two flaps with one transmitter input with AURA using the F-100 PNP as an example. The techniques can be used in general in many situations.
• Typical settings (matches F-100D setup per manual)
  • We will assume 3-position scale type flaps set on a 3 position switch. The 'half flap' position will be set at (or near) the 'center' postion (aka transmitter data set at or near 0%.
  • Using Aura, transmitter wing type is set to 1 aileron, 1 flap
  • Aura is set to two flaps and will setup two servo output ports (example S7, S8) using the 1 Tx/Rx Channel (CH6 is typical)

High Level Overview of Pro Flap Setup

• x
• x

Flap Setup

• In addition to the JR DMSS receivers listed in the manual, the RG812BX should be a good choice as well. Avoid the BPX receivers as they will not do servo pulses and serial data at the same time.
• We recommend updating to the very latest Aura Firmware v1.14 or higher and then set the 'new to Aura' JR XBUS MODE A serial data in the transmitter and the Aura.
• Using MODE A, you can physically wire/connect it just like Futaba diagram in the manual (P. 7). Throttle and Gear in the Receivers ports. Xbus to Port B in Aura.